How do i hook up my swamp cooler

Any help would be appreciated.

How to Install a Home Swamp Cooler

I'd like to get this installed as soon as possible to help with the extreme heat that my computer equipment gives off in my office. Last edited by tara; at Find all posts by tara It's very easy to do, once you hang the cooler in the window and level it, you need to cut a piece of plywood or plexiglass to go above the remainder of the window area.

This faucet adapter looks like the faucet you already have and just screws onto where your hose was and still gives you control of the faucet for watering. As far as locking the window, they sell little twist lock deals that hook onto the window frame behind the window and tighten down with a wing nut type setup. Find all posts by sammy It sounds easy enough - just hope it really is easy. I have a few more questions actually my husband does. What type of piping or hoses should we purchase to hook up to the water facet?

Your Answer

Also, is there any problems with the hoses freezing in the winter? I told my husband that you probably drain the hose before winter because we wouldn't be using the swamp cooler in the winter.

He wants to know what would be better to install above the unit to fill up the top space between the unit and the top of the window - plywood or plexiglass? Alsowhat type of sealant should be used? Often they are located at the water heater since the top cold water line going in is almost always copper.


  • .
  • dating korean male?
  • hook up dress.
  • ukraine dating services.
  • Connecting a Swamp Cooler line To a Outside Faucet – HVAC How To.
  • Swamp Cooler Startup.
  • montreal quebec dating sites;

This method often requires some digging as to find the water pipe and clear space to cut into it. Summary Hooking a water line to an evaporative cooler is not a difficult job but be sure to call a professional if in doubt.

DIY Swamp Cooler

The easiest method would be option 1 above since it does not require cutting into any pipe. If a water pipe is going to be worked on be sure to turn off the water at the Main. Any tips on how to winterize a swamp cooler?

Check the entire length of the supply line for leaks. Leaky segments will have to be cut out and a new piece of tube spliced into the line. In extreme cases, the entire line may need to be replaced.

Most plumbers recommend using copper because it's not as fragile as plastic, and it holds up better under New Mexico's summer heat and ultraviolet rays. Adjust the float inside the reservoir pan by bending the float arm up or down, so that the water level stabilizes about three-quarters of an inch below the top of the overflow tube.

If the overflow tube is leaking it may need to be replaced.

How to Hook Up a Window-Mounted Swamp Cooler - ucexipujoqen.tk Community Forums

Often, pipe thread sealant, Teflon tape or a waterproof patching tar are enough to stop the leak. Clean the water pump with a stiff brush and place the pump on the bottom of the reservoir. Plug in or turn on the water pump are your hands dry? Clogged tubes can often be cleared of an obstruction by feeding a speedometer cable or other flexible wire into the tube opening.

Connecting a Swamp Cooler line To a Outside Faucet

Plug in or turn on the blower motor, checking to see that all motor speeds respond appropriately, and that the belt, pulleys and squirrel cage are all turning freely. Reattach all side panels, and make one last check for leaks at the cooler, inside the house where the water supply line branches off from the water heater, and along the entire length of line between. Reattach all side panels, and make one last check for leaks.


admin